OBJECTIVE
Cancel out the SYSTEM FREQUENCY with destructive interference. Match the wave parameters, then DISPLACE PHASE by 180° to produce the anti-phase. When the OUTPUT flatlines, you win.
CONTROLS
Use the three sliders to match the target signal:
AMPLITUDE - Match the wave height
FREQUENCY - Match the wave speed
PHASE - Match the wave position
Each slider has a FINE control below it for precision tuning when you're close.
KEYBOARD
A / Z - Amplitude up/down
UP / DOWN - Frequency up/down
LEFT / RIGHT - Phase up/down
SPACE - Next target (after win/fail)
AUDIO
Toggle OUTPUT audio on — this is your main feedback. The tone fades to silence as you cancel the signal. Use your ears!
SCORING
Points = speed x difficulty x streak. Faster hacks and higher streaks multiply your score. Accuracy bonuses at 95%+ and 98%+ match.
MODES
PRACTICE (default) - No timer, no scoring. Take your time and learn the controls.
GAME - Toggle via the button next to HACKER INTERFACE. Timer, scoring, and auto-advance enabled.
DIFFICULTY (GAME MODE)
STANDARD (0-5 wins) - 30s timer, narrow freq range, frequent hints
ADVANCED (6-10 wins) - 22s timer, wider range, fewer hints
EXPERT (11+ wins) - 15s timer, full range, rare hints
AI ASSIST
Four tools to help your hack. Each takes 1-2 seconds — not instant!
MATCH AMP - Lock amplitude to target
MATCH FREQ - Lock frequency to target
MATCH PHASE - Lock phase to target
DISPLACE PHASE - Shift phase +180° (the cancellation offset)
TIPS
Match FREQUENCY first — the output will stop pulsing when frequencies align
Then dial in AMPLITUDE — get the wave heights equal
Match PHASE — sync the waves (output will double!)
Finally DISPLACE PHASE +180° — anti-phase kills the signal
Watch the terminal for hints about the target signal